Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Cabinet Installation Cost in Henderson?
Cabinet installation in Henderson runs $4,000 to $13,000 for most kitchens, including removal of the old boxes, new cabinet assembly, leveling, and door and drawer alignment. A small galley or bathroom vanity job can land near the low end, while a full kitchen with custom or semi-custom cabinetry, an island, and upgraded hardware pushes toward $13,000. That range covers the cabinets and the install labor; countertops, backsplash, and plumbing reconnects are priced separately.
Key Takeaways
- Typical Henderson cabinet installation: $4,000 – $13,000 installed.
- Stock cabinets cost the least; semi-custom and custom run higher but fit odd walls and ceilings common in older Henderson homes.
- Cabinet install usually pairs with a countertop installation in Henderson ($2,000 – $6,500) and a backsplash installation ($800 – $2,500).
- Whole-kitchen projects, where you’re also moving walls or plumbing, climb into kitchen remodel in Henderson territory ($14,000 – $45,000).
- Free estimates and one contractor handling cabinets, counters, and finish work keep the schedule tight. Call (833) 734-5541.
Cabinet Installation Cost Breakdown (2026)
Here’s how the money breaks down on a Henderson cabinet job. These are installed ranges, not cabinet-only or labor-only, so you can compare against a contractor quote directly.
| Line item | Typical Henderson range (installed) |
|---|---|
| Stock cabinets (10×10 kitchen, base + wall) | $4,000 – $6,500 |
| Semi-custom cabinets (10×10 kitchen) | $6,500 – $10,000 |
| Custom cabinets (10×10 kitchen) | $9,000 – $13,000+ |
| Old cabinet removal and haul-away | $300 – $800 |
| Cabinet assembly and installation labor | $1,800 – $5,500 |
| Kitchen island cabinet install (add-on) | $3,000 – $10,000 |
| Bathroom vanity cabinet install | $800 – $3,000 |
| Soft-close hinges and drawer slides (upgrade) | $300 – $1,200 |
| Crown molding, fillers, and end panels (finish carpentry) | $400 – $1,500 |
| Plumbing reconnect for sink and dishwasher | $250 – $700 |
Full-service reference: most Henderson cabinet installs land inside the overall cabinet installation service range of $4,000 – $13,000. The two biggest levers are cabinet grade (stock, semi-custom, custom) and layout changes. Keeping the sink where it is saves money on plumbing. Moving the range or adding an island means new electrical and possibly a permit. If the kitchen’s ceilings and walls are out of square, filler panels and scribing add carpentry hours. And kitchen size matters more than most people expect: a 10×10 footprint needs roughly half the boxes of an open 15×20 plan, which is why two neighbors in the same Henderson subdivision can get very different quotes.
What Affects Cabinet Installation Pricing in Henderson
- Cabinet grade and brand. Stock boxes from a big-box store cost the least; semi-custom lines like KraftMaid and Wellborn let you tune dimensions and finish without full-custom pricing. Picking among multiple brands in a single category is a real advantage, and it’s why we carry competing lines rather than a single-vendor take-it-or-leave-it offer.
- Kitchen layout and plumbing moves. Swapping cabinets in place is cheaper than re-plumbing. If the sink, dishwasher, or range relocates, expect new supply and drain lines plus an electrical run, and that work adds to the install total.
- Henderson’s dry heat and hard water. The valley’s low humidity lets wood cabinets stay stable, but intense summer sun through west-facing windows bleaches finishes over time and hard water spots the sink base. Choosing a factory finish and a moisture-resistant sink cabinet matters here in a way it doesn’t in humid climates.
- Wall and ceiling condition. Homes in older Green Valley and downtown Henderson neighborhoods often have walls and floors that have settled. Leveling cabinets and cutting filler strips to hide the gap takes extra hours, and that shows up in the line-item labor.
- Permits and code. Replacing cabinets in the same footprint usually needs no permit. Converting a blind corner into a pantry or moving a gas range calls for inspection, and Clark County permit and inspection fees get folded into the job.
- Hardware and detailing. Soft-close slides, pull-out organizers, crown molding, toe kicks, and under-cabinet lighting are upgrade items. They raise the price, but they’re cheap relative to the cabinets themselves.
How to Save on Cabinet Installation
There are honest ways to shave the bill without cutting corners on the install itself:
- Keep the footprint. If your sink and range stay put, you avoid plumbing, electrical, and permit costs. That alone can save a few thousand in a Henderson kitchen.
- Go semi-custom instead of custom. Semi-custom lines hit most layouts at a fraction of custom pricing, and a good installer can add fillers and panels to make them look built-in. You’ll save real money and still get a cabinet that fits your walls.
- Reuse the boxes, replace the fronts. If the cabinet frames are solid, new doors, drawer fronts, and hardware refresh the kitchen for a lot less than full replacement. Ask us to assess whether your existing boxes are worth keeping.
- Bundle the finish trades. Installing a new countertop and backsplash at the same time as the cabinets cuts mobilization and scheduling. One contractor, one visit, one point of contact.
- Choose soft-close as a bundle. Buying hinges and slides as part of the cabinet order is cheaper than adding them after the fact.
Free estimates take the guesswork out of the range above. Call (833) 734-5541 and we’ll walk your kitchen, measure, and put a real number on paper.
Why Henderson Homeowners Choose One Contractor for Cabinets and the Rooms Around Them
A cabinet install rarely stays a cabinet install. The countertop has to come off, the sink cabinet has to reconnect, the backsplash has to be patched or replaced, and often there’s a ceiling or floor repair that comes up mid-job. When those tasks belong to three different trades, the schedule slips and the finger-pointing starts. Slatestone Contractors works from one contract and one schedule, so the same team that sets the cabinets also handles the related interior and exterior work around them. That’s the coordination relief homeowners are usually looking for when they start a kitchen, and it’s the same reason we can pull a full kitchen remodel or a bathroom refresh into the same project if you decide to go wider.
It also matters which brands are on the table. Our material roster spans more than 50 name-brand suppliers across every major home system, including cabinetry from KraftMaid and Wellborn, countertops from Cambria, Caesarstone, and Silestone, and plumbing fixtures from Kohler, Moen, Grohe, and Toto. That gives you real choices across competing brands in each category instead of a single fixed offer. The same coordinated approach covers the rest of the house too, from bathroom remodel in Henderson work to roof replacement in Henderson and window replacement, and it means the seam between interior and exterior phases of a bigger plan doesn’t fall on you to manage.
Cabinet Installation Pricing by Kitchen Scale
Scale is the other big variable, so it helps to see the range anchored to a few common Henderson jobs:
- Bathroom vanity cabinet only: $800 – $3,000, often folded into a bathroom vanity installation.
- Condominium or small galley kitchen: $4,000 – $7,000 for stock or semi-custom boxes.
- Standard single-family kitchen: $6,000 – $10,000, typically semi-custom with a countertop swap.
- Large or open-plan kitchen with an island: $10,000 – $13,000+, especially with a new kitchen island added.
- Full kitchen with layout changes: $14,000 – $45,000 when it becomes a remodel with new floors, lighting, and finishes.
If you’re weighing a small scope against a bigger one, a small kitchen remodel in Henderson ($9,000 – $20,000) is the middle path between a cabinet-only install and a full gut.
Frequently Asked Questions: Cabinet Installation Cost in Henderson
What’s the average cost to install kitchen cabinets in Henderson?
Most Henderson homeowners pay $4,000 to $13,000 installed, with a typical mid-range job around $7,000 – $9,000 for semi-custom boxes and standard labor. Call (833) 734-5541 for an exact quote on your kitchen; estimates are free.
Is it cheaper to reface cabinets or replace them in Henderson?
Refacing is usually cheaper than full replacement when the boxes are solid, often running well below the replacement range because you keep the frames and only change the fronts, doors, and hardware. If the boxes are warped or the layout is wrong, replacement is the better spend. Call (833) 734-5541 and we’ll tell you honestly which makes sense for your cabinets.
How much does a cabinet installation cost if I keep the same layout?
Keeping the sink and range in place keeps you near $4,000 – $9,000 for standard kitchen cabinet replacement, because you skip plumbing, electrical, and most permit fees. Moving fixtures pushes you higher. Call (833) 734-5541 for a same-layout estimate.
Do I need a permit to install cabinets in Henderson?
No permit is needed if you’re replacing cabinets in the same footprint; a permit is required once you move plumbing, gas, or electrical. Clark County inspection fees get folded into the job total when a permit applies. Call (833) 734-5541 and we’ll sort out whether your project triggers a permit.
How long does a cabinet installation take in Henderson?
A standard cabinet swap takes two to four working days, and a full kitchen with an island and countertops runs one to three weeks. Add time for custom cabinet lead times, which can run several weeks. Call (833) 734-5541 to schedule a free measurement and get your timeline.
Contact Slatestone Contractors for a Free Cabinet Estimate in Henderson
If you have a Henderson kitchen in mind, get a real number instead of a range. We’ll walk the space, measure, and put together a cost on paper across the cabinet brands that fit your plan, along with any countertop and backsplash work you want bundled into the same schedule. From the roof to the pavers, we handle the full scope under one contract, which is the whole point of working with a single contractor. Call (833) 734-5541 today for a free estimate, and we’ll get your kitchen measured and quoted without the runaround.
Pricing reflects the Henderson market as of 2026. Slatestone Contractors offers free estimates – call (833) 734-5541.
What Our Customers Say
"He was upfront about a soil issue that added cost early rather than absorbing it and surprising us at the end."
— Lina Mansour"Ground up build. Permits, foundation, framing, all of it, and he ran the schedule tightly enough that the subs were never tripping over each other. Finished within a month of a fourteen month estimate."
— Jodi Delaney"Excellent build. Costs came in about six percent over the original contract, driven mostly by material price movement during the build, which he documented each time."
— Cole Rhodes